Originally Posted by
kc8qpu
Ok so I got a chance to really dig into the car more tonight. First I found that my aluminum motor mount was broke. Apparently this caused the spur gear to be bad. Can I still get the aluminum motor mount to replace it? Also what is the best way to change out the spur gear? From the looks of it I need to take of the c-clip, end gear, bearing then some how press out the pin to take off the mount for the spur gear. Or is there an easier way of doing it?
Which chassis do you have, Tub or Carbon fiber, The motor mount for the tub chassis isn't as difficult to find as the CF chassis.
down load the tc4 manual from the Assoc site. Build the diffs as per the instructions. Be careful, the plastic diffs are built differently than the steel. I prefer the the front diff tighter than the rear. If the plastic diffs are too loose they warp very easily!!!!!!