Originally Posted by
Cain
looking to make 8 min minimum here, been toying with some 6500s instead.
I'll give him a holler and see what is up for stuff there and compare.
Been spoiled with inboard packs so not fond of prewires other than 1/8 electric which I have one now that is a 5 mm one too.
I have heard that SMCs have issues with using some 4mm plugs, is that still a prob or is it a non issue?
See quite a few come thru our local track ( all types an sizes) and only one issue I can remember that was a couple months ago. And that's because he dropped it off the table and it landed right on the corner where the bullet was. But the guy split the cases and resoldered it. A little tape job and I believe he was running it this past weekend.
But there are always chances. Only problem with mass production I can see. But Im sure if you get one that craps out within a month or 2, SMC will take care of you as most manufactures would/should.