View Single Post
Old 07-02-2002, 11:37 PM   #4
ijnek
Tech Elite
 
ijnek's Avatar
 
Join Date: Apr 2002
Location: S'pore & M'sia, JB
Posts: 2,510
Send a message via ICQ to ijnek
Default

should b ur gearing...
change 2 a larger pinion,...
then set ur mesh correctly...between the teeths of ur spur and pinion gear,slip a thin piece of paper between them and then tighten the mesh...after u have screwed ur motor up,turn the spur and out the paper comes.tat way,u will have a better mesh between ur spur n pinion gear...
ijnek is offline   Reply With Quote