R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 02-10-2005 | 01:35 PM
  #10945  
JohnB's Avatar
JohnB
Tech Addict
iTrader: (1)
 
Joined: Aug 2002
Posts: 674
From: Oregon City, Or
Default
Originally posted by vtl1180ny
Has anyone else tried throwing one of these http://www2.towerhobbies.com/cgi-bin...4&I=LXFKL0&P=K

Andd one of these (Non CRC cars's) http://www.teamcrc.com/crc/modules.p...od&prodID=4121

On their diffs yet to free it up and take some load off????

Works awesome and you can't beat it for under $5 (CRC guys, under $3.00)....
Have you tried one of those thrust bearings. I was just looking through Tower to see if I could buy one like the one that came with my Slapmaster kit. I'm at work and can't measure it but since it goes on a 1/4" axle, the ID should be about 6.3 mm right?
This one looks close:
http://www2.towerhobbies.com/cgi-bin...?&I=LXCDV0&P=7
and then the next size up I see is 8mm.
JohnB is offline  
Reply