R/C Tech Forums - View Single Post - What is the best way to break in a new ening?
Old 02-10-2005 | 12:20 AM
  #21  
danjoy25's Avatar
danjoy25
Tech Champion
iTrader: (38)
 
Joined: Oct 2003
Posts: 5,203
Default

Originally posted by TRAJ
Yes that is what i thought but he means the 3rd tank in the second lot (6tanks broken into 2 lots 3/3).

3 tanks in two lots... 1set of tanks run 3 tanks straight without shutting the engine down.

After the 3 are done shut it down and let it cool.

Then repeat the same thing again for another 3 tanks but on the 3rd tank of the second lot (6th tank) start to bleep the throttle in 2 sec intervals.

Then let it cool and your done then just run the car round the track and tune it to race settings.

Be sure to refuel the tanks Quick as the engine will rev high when you open the tank.

I spoke to Josh who wrote the run in procedure.

Hope this helps
Thanks for clearing that one, This method must only take less than an hour as 3 full tanks on full throttle on very rich setting might only last around 5 minutes then cooling period of 15 to 30 minutes the another 3 tanks again on full.

Still very hesitant about the WOT especially the first few tanks as I might break the rod though.
danjoy25 is offline