Originally Posted by
Tony Newland
4mm would be like 5deg of toe in...
0mm would be about .5deg antisquat...
The setup sheets are wrong on the antisquat, they are based off the older 3mm rear screws. Since they have gone to the 4mm they had to separate the holes to accomodate the larger screws and that equats to approx .5deg more antisquat than listed....
Check out the lower left side of the setup sheet to adjust your toe/AS
http://www.petitrc.com/setup/schumac...rCougarKF.html
so for toe,if you run 3mm washers in the rear block and 0 on the front block and subtract those two (3.0-0=3.0),then use that as your "difference" and look that up on the chart to see what your toe is. is that how you figure out this?
sorry if im thick headed but i just want to understand it completely.