Originally Posted by
TheExpandingMan
I'm having steering issues.
On power up, I tested my steering, but one wheel was flush against my tool box. Ever since then, I get the steering problem shown on the video below.
I've tried to tighten the servo saver per the manual as much as I can (not the best design, I have to say). I've removed and remounted the servo and used locktite.
I've thought about replacing parts, but nothing looks damaged to me.
The servo mount seems very flimsy, as you will see from the wobble below.
Anyone had this problem and found a fix?
https://www.youtube.com/watch?v=krIQ...ux25UpRMZji6Pg
I would think your steering linkage (bellcrank) is bound up most likely at the bottom of or the steering post. The bellcrank has bushings riding on the posts, you may have one seized or a bent post. also check your servo saver spring make sure its not broke. It does seem that the servo saver is just to loose. Good luck hope it just a simple easy fix. These trucks are put together in mass production in a hurry (new truck in high demand) sometimes things are just not right coming out of the box.