R/C Tech Forums - View Single Post - Revo Brushless Conversion Project
Thread: Revo Brushless Conversion Project
View Single Post
Old 12-21-2014 | 06:07 PM
  #5  
Graveyard's Avatar
Graveyard
Tech Regular
iTrader: (5)
 
Joined: Nov 2011
Posts: 275
Default
Originally Posted by JatoTheRipper
That looks great! I want to do this to my Revo 3.3. Did you also make the motor mount?
Thank you and I did not build that mount. It is available from Integy although I do have some face plates that have the motor section offset about 3/16" of an inch to allow an 1/8th scale motor to mount up without interference.
Graveyard is offline  
Reply