R/C Tech Forums - View Single Post - New CRC F1 At IIC
Thread: New CRC F1 At IIC
View Single Post
Old 12-20-2014, 09:18 PM
  #245  
liljohn1064
Tech Champion
iTrader: (17)
 
liljohn1064's Avatar
 
Join Date: Sep 2008
Location: Deerfield, WI
Posts: 5,919
Trader Rating: 17 (100%+)
Default
Originally Posted by InspGadgt
I've been finding that on a lot of metric nuts lately...the hole in the nylon part is just too small and so way too tight. On the M3 nuts I've been running a tap through them since I have a 3mm tap. The M4 nuts I threaded onto the steel front axles first to loosen them up.
Good idea. I can always run one of the front end mounting screws through to thread them.
liljohn1064 is offline  
Reply