R/C Tech Forums - View Single Post - Team Associated TC6 Thread
View Single Post
Old 12-18-2014, 08:36 AM
  #10185  
billdelong
Tech Champion
iTrader: (33)
 
Join Date: Mar 2011
Location: Austin,TX
Posts: 6,188
Trader Rating: 33 (97%+)
Default

yes, lift it out of the bulkhead, rotate it, then re-insert the bearing holder so that each notch is in the same slot on both sides of the bulk head. Keep increasing one slot at a time until you reach the desired tension. With the TC6... I think the grooves are inside the plastic bearing holder itself... same concept with XRay.
billdelong is offline