R/C Tech Forums - View Single Post - The Speed Passion Thread

12-16-2014 | 10:15 AM

#12787

Nexus

Tech Champion

iTrader: (42)

Joined: Nov 2002

Posts: 7,758

From: Chicago, IL

Quote:

Originally Posted by Jerem

Hi Nexus,

I think you mean the Value button ?

Even, this one or the other are doing the same result.

I've tried to re-flash the card in 2.4 and then in 2.7 and tried to re-flash the Esc, not working, always the same messages just after choosing a firmware (see pics).

Thanks,

Jérem'

Let me look at this later tonight and get back to you.

Quote:

Originally Posted by MatJ

Hi,

I'm running a SpeedPassion GT 2.0 LPF (which may seem outdated to some) and was wondering if I desperately need the SP programming card to update the firmware or are there other cards that I can use ?
I know the Hobbywing 2 in 1 and 3 in 1 work (according to the forum) but is it the only one that works ? Any other cards that work too?

Finally, would it be safe to run no fan on the Speedo while running a x12 13.5 t?

Thanks in advance

Regards,
Mat.

You don't have to run a fan on the speed or toward the motor, but every little bit helps in onroad. If I had a choice I would put a high power fan blowing to the motor.

Quote:

Originally Posted by CamLS

Hey guys, would I be correct in assuming that I can replace the Reventon Pro capacitor with any 2200uf 25V cap?

It's been done. I've seen others put other brand caps on with no issues. In either, a cap is a cap is a cap :P

Reply