Originally Posted by
guru83
Hi, i have a problem with AM49-3. When i use it with am33-5 stiffener, my AT31 FFG Alloy Rod is completely stuck.
If i use AM49 long ffg tower, alloy rod moves freely, but i can't install am33-5 stiffener.
This happen on my C01AL-S chassis.
It's safe to run without stiffener? Or there is a way to unstuck alloy rod with am49-3?
One possibility...
By chance are you mounting the awesomatix servo in the center ? If so, make sure your screws holding the awesomatix servo are short ( I believe 5mm ) so they won't run into am33-5.