R/C Tech Forums - View Single Post - Tekno ET48 Build - TP 4070
Thread: Tekno ET48 Build - TP 4070
View Single Post
Old 12-13-2014 | 10:42 AM
  #6  
0verkill's Avatar
0verkill
Tech Master
iTrader: (8)
 
Joined: Oct 2010
Posts: 1,189
From: Birmingham, AL
Default
The ID of the motor mount insert is 12.90mm and the OD of the KD 8mm bore pinion gear is 14.12mm. Just 1.22mm too big. I was looking through the Tekno parts and they have a lightened motor mount insert that looks like it may have a bigger opening through the middle or it could be opened up much easier to fit this larger pinion gear.


Last edited by 0verkill; 12-13-2014 at 11:10 AM.
0verkill is offline  
Reply