R/C Tech Forums - View Single Post - Serpent Spyder SRX-2 Mid Motor Buggy Thread
Old 12-10-2014, 11:52 AM
  #1677  
wrightcs77
Tech Elite
iTrader: (551)
 
wrightcs77's Avatar
 
Join Date: Mar 2007
Location: Blaine, MN
Posts: 3,827
Trader Rating: 551 (100%+)
Default

Originally Posted by louie8269
Just got my MM and got the electronics in and started my indoor carpet setup based on this one: http://www.petitrc.com/setup/serpent...s_MIO20141109/

I have it all setup the same but I have my rear shock towers bottomed out and can only get down to 22mm ride height. Why is that? Only difference is I put blue springs in the rear instead of green (because that's all I had) but will that make a 5mm difference? Are the green springs shorter? I'm going to stop and pick up some grey AE springs that were mentioned earlier in this thread for carpet but I'm not sure that will lower it down to the 17mm this calls for.

Also, does anyone have a link to a good stock 17.5 blinky MM carpet setup sheet? I cannot seem to find one. Thanks!
Serpent makes shorter rear springs specifically for carpet running.
wrightcs77 is offline