TKR6140 Supplemental Instructions:

Hello, we wanted to let our customers know that the newly released spring perches and shock boots require a different procedure when assembling/building them due to the new shock boot design.

For the SCT410, EB48.2, NB48, ET48, NT48:
1. Unthread your current shock rod ends. Be sure to use shock shaft pliers so you don't scratch or nick the surface of the shock shaft. Remove any o-rings used to limit up travel if any are installed.

2. Install new shock boot onto shaft and secure around shock cartridge cap as shown:

3. Install new rod end as shown in the second image. Be sure to use shock shaft pliers so you don't scratch or nick the surface of the shock shaft.

With the rod end fully tightened down the shock boot should look like this:

Rebuild the shock like you normally would, just remember that the shock boot will have to be pulled down over the rod end to set rebound and is not able to slide over and off the rod end like the old shock boots.

Once you refill with oil and bleed the shock to the desired rebound you can install the shock boot back into the proper position and install the spring, spring perch and use a 1.5mm hex wrench to install the set screw. The set screw is the length of the spring perched and should be flush with the perch when installed as shown

That's it, enjoy your new shock boots and spring perches!
-Thomas