Originally Posted by
ViperZ
I like it, great looking driver!
I use to race 1/12 electric back when ROAR required all cars to have a driver figure, the good old days
I had one taped to my servo of my chassis which position wise was correct for most Group C, prototype and Can Am cars. For sedans I made an plated interior, but I like your solution.
It was just some bits & pieces from past cars owned, I believe the little CF "arm" was made by Exotek and used to raise the transmission on a 22 buggy / SC truck. Something you could easily make yourself. The mount post was from a Schumacher SV buggy. With the driver figure, I made the hole just big enough to barely fit the post through so it's a tight fit. With the body clip in place, it stays put pretty well. Easy to rotate vs. full removal also, if you just need to get at some wiring quickly, ect.