Originally Posted by worm304

OK...NEED HELP!

Finishing up this build and have an issue with the clearance of the nut on the end of the screw that goes through the steering arm and through the hub. It gets stuck on the A arm. When the car is sitting normal without compressing the shocks it looks like the following... when I push the chassis flat it clears without a problem. I checked the and rechecked and I believe it is assembled correctly. Per the instruction, the initial bumpsteer setting two washers above and below the steering ball link. I took one washer out from above and below to see if that would help, but it didn't... I made sure I am using the correct ball with the flange faced correctly. I hope I explained it correctly and the picture helps. Thanks for any help you could lend!!