Originally Posted by
ob1n
I see it in photos all the time; brushless systems neat and tidy under the body. I was about to do the same to my rig.....but read in the instruction manual for castle creation that you do NOT cut the wires! Now, I'm going to make the assumption that statement is more of a "warranty safety"?! I.E..... They say that to keep the warranty department from being flooded with claims?!
What is everyone's advice and/or experience with trimming brushless motors/ESC wiring?!
I can't think of an esc or motor where I haven't cut the wires to fit under the body cleanly. You would need to contact them to see what voids the warranty though but I know Novak's policy is, if it's soldered properly then it wont void the warranty.