Originally Posted by
hairymuffin
rear hangers..i always ran d-in/d in be cause most were running it..i now run c in c in..or even b in..most will say thats way too much toe? who cares,as long as it works.
If you use the same insert front to rear, you don't change toe-in, it stays at 3° per side. You only change overall width and roll center (wider means less roll).
C in/C in is 3 degrees, as D in/D in or B out/B out.
D in front/C in rear is 3.5 degrees
C in front/D in rear is 2.5 degrees
Etc.