Originally Posted by
oquela
Hello all,
I need a bit of help. I had my GT3b hacked, using 6.1 firmware. i've never used more than 2 channels.
I need to use Ch.3 as an AUX channel now. I installed a Telebee r/c gyro onto my 2 wd Slash-it has an extra yellow wire that goes into Ch3.
My belief is that this allows the gyro to be adjusted remotely/turned off when not needed using dual rate from the radio system (instead of adjusting only on gyro itself)
Nothing happens when i click in CH3 button, or ch3 trim on my radio. Tried swapping connector on receiver(only has a yellow wire-dont know which side this is supposed to go on)
How do I set up my hacked GT3b to have a useable ch3 AUX button? It has something to do with setups, but I'm clueless to how this is done.
Thanks!
Ps: here's the telebee manual:
http://www.telebee.com.hk/Download/R...ANUAL%20R1.pdf
The manual says that it can operate in single rate mode (only 1 setting, always on) or dual-rate mode (One setting when CH3 inactive, alternate setting when CH3 active) if you connect the plug. It does not mention how to connect it or how to set what the 2 rates are. To test your CH3 working properly, just plug your steering servo into CH3 and activate the CH3 button on the remote to see if it makes the steering servo do something. If it does, then you need to contact the gyro manufacturer on how to set it up properly with the Dual-Rate setting.