R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 11-16-2014 | 03:51 PM
  #41628  
ccm399
Tech Fanatic
iTrader: (8)
 
Joined: Jul 2003
Posts: 835
From: Medina Ohio
Default
Originally Posted by InspGadgt
The Tekin has lights on it that blink for each of the 3 sensors as they are tripped. I would check to make sure these lights are flashing when the motor is turned. If they are not, and you have changed the sensor wire and sensor board then likely there is something broken in the ESC.
Hi there,

Can you point me to any documentation on this feature? I just tried to turn the motor and the only flashing I get is the ESC blinking the "blinky" mode sequence.

I just looked at the RS manual on Tekin's site and I don't see this in it. Is this maybe a Gen 2 feature?

EDIT: Found it... Off to test again. I am going to try taking the esc out of blinky mode 1st this time.

Thanks!

Chris
Last edited by ccm399; 11-16-2014 at 04:03 PM.
ccm399 is offline  
Reply