Hello all,
I need a bit of help. I had my GT3b hacked, using 6.1 firmware. i've never used more than 2 channels.

I need to use Ch.3 as an AUX channel now. I installed a Telebee r/c gyro onto my 2 wd Slash-it has an extra yellow wire that goes into Ch3.

My belief is that this allows the gyro to be adjusted remotely/turned off when not needed using dual rate from the radio system (instead of adjusting only on gyro itself)

Nothing happens when i click in CH3 button, or ch3 trim on my radio. Tried swapping connector on receiver(only has a yellow wire-dont know which side this is supposed to go on)

How do I set up my hacked GT3b to have a useable ch3 AUX button? It has something to do with setups, but I'm clueless to how this is done.

Thanks!

Ps: here's the telebee manual:
http://www.telebee.com.hk/Download/R...ANUAL%20R1.pdf