View Single Post
Old 02-04-2005, 09:09 PM
  #12251  
Blakesrc
Tech Addict
iTrader: (14)
 
Blakesrc's Avatar
 
Join Date: Oct 2002
Location: Grover Beach/Palm Desert, CA
Posts: 703
Trader Rating: 14 (100%+)
Default

Jaybee, i think Matt is talking about the servo arm that slides onto the splined output piece. I also wanted to mention that i had a centering issue for a couple of weeks after i switched from a cgm servo saver to just a plain servo arm. I finally figured out the cause was from using the same screw from the cgm servo saver which was to long to actually hold the regular servo arm all the way on and would cause the servo arm to skip a notch every once in a while.

Blake
Blakesrc is offline  
Reply With Quote