R/C Tech Forums - View Single Post - Team ORCA USA Discussion Thread
Thread: Team ORCA USA Discussion Thread
View Single Post
Old 11-10-2014, 10:50 AM
  #588  
Xpress
Tech Master
iTrader: (3)
 
Xpress's Avatar
 
Join Date: Nov 2001
Location: Land of high taxes and bad football
Posts: 1,807
Trader Rating: 3 (100%+)
Default
Originally Posted by trackout
Better than most of the current TX motors, maybe not as good as the first TXs. I find it likes a lot of timing (just short of the plus mark) and I'm gearing around 3.8 on a relatively small track (80ft straight).
I read the bottom bearing is larger, but not sure if that is ID or just the OD? I saw it comes with a 12.4 rotor, but if the ID of the bottom bearing is larger none of the HT rotors will fit?
Xpress is offline  
Reply