View Single Post
Old 11-08-2014, 06:54 PM   #8990
[email protected]
Tech Regular
deftones.jt@gma's Avatar
R/C Tech Elite Subscriber
Join Date: Mar 2014
Location: Fowlerville, MI
Posts: 343
Trader Rating: 26 (100%+)

Originally Posted by JW91 View Post
I posted the mod on the nation. Raising the brace will help reduce/ eliminate any chassis preload that may occur by just adding o rings to the top. It let's the top of the brace truly float rounds the screws. Shim it just high enough to allow you to slip the o ring under the top (a few thousandths less is ok). Only tighten the screw enough so the are all touching. No need to CLAMP them down.
Sounds good.... Gonna try it this week and run some laps!!
STOCK FT RC10B5M Trinity D4 17.5 Hobbywing v3.1
MOD FT RC10B5M Trinity D3.5 8.5 Hobbywing v3.1
deftones.jt@gma is offline   Reply With Quote