I have the reventon s esc and turnigy gtx3 tx and rx, i loaded everything up in my computer and used the programmer to program the esc. I have a solid orange light and a red light that double blinks every 2 seconds or so. The troubleshoot section in the reventon manual doesnt say what 2 red blinks mean, it does say the red led blinking means low voltage but Ive checked the lipo over and over and it appears to be fully charged. Roar website says the 2 red blinks means (blinky mode) which is what I programmed the esc for , stock 0 , I tried to disable LVC and temp shut off but still the motor and servo do nothing when I attempt to use the rx. I have a solid red light on the rx so I assume it binded ok. I set up the tx settings as well. Does anyone know why its not working for me ? One thing I did find that I made a mistake on was when I shortened the esc wire that goes to the rx I think I had the neg and pos wires reversed at the rx side of the wire plug, would that have burned something out ? I have now cut that plug off and switched it to match the s,+,- at the rx, but my computer recognizes that my esc is hooked up when I use the wire to the led programmer, thats how I was able to run the settings to the esc. Help appreciated !