R/C Tech Forums - View Single Post - Keeping stuff out of the fan on an rx8
Thread: Keeping stuff out of the fan on an rx8
View Single Post
Old 11-02-2014 | 06:22 AM
  #4  
dan_vector's Avatar
dan_vector
Tech Elite
iTrader: (27)
 
Joined: Oct 2013
Posts: 4,333
Default
Originally Posted by Hoese37
Make sure the fan is blowing up instead of down, as it was intended.
Sorry Hoese that's not correct. All fans should be installed to blow air down over the heat sink of the esc. Definately not pull air up and away from the heatsink. This is the intended installation of the fan. The tekin manual found here http://www.teamtekin.com/assets/tws_manual_rx8gen2.pdf also states the same under 'fan installation'.
dan_vector is offline  
Reply