Originally Posted by
ViperZ
I readjusted my chassis to Cartwright's settings, even though I'll have to do it all over once the Yokomo springs arrive. Surprisingly I wasn't too far off, with exception of the droop. Seems I had more droop than the 5.5 as I set it up as a ratio of ride height, as instructed by a fellow member. It was about 7-8mm
I'm (I think) one of the few that uses the plain old droop gauge. Make sure you measure to the notch on the arm like the instructions say and not the bottom of the arm.
The yokomo springs are a big difference to me. I'm not sure exactly why but after trying AE, RSD, Tamiya etc, they are more consistent and easier to drive hard. RSD came close.
That setup rolls a fair amount. I'm testing a slightly more aggressive setup now. I'll get some more time this weekend finally