Originally Posted by
Nexus
I'm not 100% following you, but I will attempt to answer your problems.
1. You only need your PC if if you want to change Firmware/Profile from say Stock0 to Mod1 or similar. If you just want to change settings within a Firmware you just need the programming box. All the drag brake, protection settings, etc. can be set by just using the programming box.
You should double check your are using the correct port to plug your ESC into the programming box. It should be the middle one on the blue box. Also make sure you are matching the positive and negative connections. I just had this issue with a local racer who described the same problem and thought his programming card was bad.
Also note the following when using Reventons...
PC + Programming car connection to ESC = DO NOT have battery connected
Programming car only to ESC = connect battery for power
I did connect the program card correctly, all that needs to be done for connecting the esc to the computer has been done correctly.
I don't understand it eather, it should be possible to use only the program card without my computer for changing the esc settings.
So far i'm unable to do so.
I will try it again and hopefully it works correctly.
Thx for being helpful.