Either gear diff will fit either car.
Here's how I resolved the friction problem when the screws are fully tightened.
.
.
.
.
.
.
.
.
.
.
Wait for it...
.
.
.
.
.
.
.
.
.
I didn't tighten them fully.
For realz...
That and I mix and match the bushings. One white, one black. Or I sand down one bushing.
BTW, the flanges should be on the outside of the mount and will not touch the bearing inside the center pulley.
Last edited by .crispy; 10-23-2014 at 02:50 PM.