Originally Posted by MantisWorx

Put the the bladder on while the shaft is up and when you lay the bladder on "roll" it to one side so that the extra oil comes out. If you just lay the bladder on top and give the oil no where to go you will have rebound. Try that and see how it goes!

After you have that part figured out, install the cap with the bleed screw completely out, tighten the cap all the way down, leave the shaft up and to be honest i would just leave the bleed screw out, but if you want to use the bleed screw, screw it in while the shaft is up. you should get as close to zero rebound as you can with this technique.