1/8 Buggy Lite Class wiring advice (2s on saddle pack buggys)
I have a sworkz s350 be1 EVO.
I bought and went to norcal hobbies only to find that it moved to a new location which runs 1/8 lite class due to ssftey and liability concerns.
I like the buggy but the saddle pack now becomes a problem when it was intended for 4s.
Sworkz s350 Be1 Evo
AE SC1300-BL (130amp)
HobbyWing EZRUN Sport 3656-4000KV 4 Pole
Most likely going to stick to 17t pinion.
My question is what would be the most effient way to wire this for 2s? Should I stick with a single saddle pack 7.4v from hobbyking(90c)? To balance it better?
The 1/8 lite class caught me off guard and I never heard of it until now. I just want to get some racing done as soon as possible.
I also have a rc8.2e but its much much heavier.
Any advice and I'd be greatful.