R/C Tech Forums - View Single Post

02-01-2005, 08:08 PM

#19904

InitialD

Tech Prophet

Join Date: Feb 2002

Location: MORDOR

Posts: 19,679

Trader Rating: 0

Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Solid Front Axle set up

Quote:

Originally posted by Taylor-Racing
jag,
I think cheapskate D's method is to just crack open the vice enough so that when you hammer the pin, the pin will pass down the gap in the slightly open vice.
You can also use, say, a 6mm nut sitting on the vice (or anything heavy/solid) to support the round part of the doggie while you hammer the pin out.
Yes, I've been a cheapskate, on occasion, too.

That's correct mate.

BTW, it takes one cheapskate to know the other. And I think you would agree that cheapskateness

is paramount to RC survival.

Reply