Originally Posted by
b20btec
Where are you basing this comment from? I didn't read anywhere that kimbrough was even mentioned, may have missed it.
Well, you read it now.
Kimborough is a well known company and it's american. They make servo savers for all servos, and spur gears in various pitch standards.
What do I need to base this comment on? A listing on the stock exchange?
I have used them for a long time and recommend them. Never had any failures or problems of any kind, and no I am not associated in any way with the company. I f anything I hate it because it's difficult to get their stuff outside the US.
And compared side by side, I would say their savers are on par with Xray's and a lot cheaper. Also, their design system gets around the inherent problem of clip springs which push hard against plastics on a very small surface area hence are not prone to destroying the plastics and introduce slop.