Originally Posted by
Salkin
Just curious, the aluminium Tamiya servo horn is a solid part. Either it did not fit the spline on the servo (too big) or the ball stud attached to the end of the servo horn was loose.
It actually fit perfect, along with the ballstud, and 3mm screw. I believe the problem occurred when I removed it to swap servo. I knew it was going to be a pain to get off, when I got it back onto the new servo that's when the play came about but didn't realize it until I did a swap for a xray saver.
I said earlier in a post I gave up, but I was setting up the car for outdoor I wanted to install a servo saver. Anyways it came off a lot easier than before, that's when I knew. Putting it on the setup station for throw before and after pretty much confirmed it.