R/C Tech Forums - View Single Post - 1/8 e buggy servo Question
Thread: 1/8 e buggy servo Question
View Single Post
Old 09-24-2014, 10:34 PM
  #6  
theblitzkidd
Suspended
iTrader: (11)
 
Join Date: Mar 2012
Location: Cali
Posts: 4,003
Trader Rating: 11 (92%+)
Default
Originally Posted by WagwanBumba
It's a bit of a trade off really ... high speed, lower torque may translate to lower turn speed as the rated numbers I would assume are for no-load. I would go for a higher torque servo and tighten down the servo saver. I went from 1258TG to a 2270SG and really notice the difference!
I'm debating on the 310 oz at .10 speed VS 488 at .15 speed ??? Im trying to balance on torque and speed not sure what other inputs il, get here
theblitzkidd is offline  
Reply