Originally Posted by filippimini

Hi Guys,

Just bought a 120a Turbo. I have set it using the program box as follows:
Operation mode *1. For/Brake
Initial Brake 3. 20%
Drag Brake *2. 5%
Brake Strength *4. 80%
Voltage Cutoff *3. 3.2V/Cell
Punch Profile 9. Level 9
Neutral DeadBand *2. 3%
Boost Timing *1. 0Deg
Turbo Slope *4. 18Deg/0.1s
Turbo Timing *1. 0deg
Boost Timing *5. 4000
Turbo Delay *3. 0.1sec
Boost Timing ACC *2. 100RPM/deg
Reverse Speed *3. 75%
Drive Frequency *1. 8KHZ
Brake Frequency *1. 1KHZ
Temperature Set *1 On

When Its on the orange light is blinking. Is this Setup correctly for Blinky class?

Cheers
Ryan