R/C Tech Forums - View Single Post - Hyper 7 1/8 Scale cogging Issues
Thread: Hyper 7 1/8 Scale cogging Issues
View Single Post
Old 09-17-2014 | 02:37 PM
  #5  
Bobbyknuckles
Tech Rookie
 
Joined: Feb 2013
Posts: 9
From: leawood kansas
Default
Originally Posted by bob.less
If its a Hyper7 it should be a 46 spur I believe ? Is it plug and play or self soldered contacts ? Are you running a non sensored motor in sensored mode ?
Hi bob,
thanks for the hep. To answer your question it's soldered connections . I did them my slef , but after looking at my soldered connection that could be it. It's a sensored motor and ESC. the ESC has A, B ,C connections for the motor.
Bobbyknuckles is offline  
Reply