Sanwa Vortex Zero esc/RX472

The setup with this esc and the transmitter is like the other esc, then you have to setup the remote to be able to change the parameter of the esc via the transmitter.
I had fun with the Japanese instruction but now there is an English manual
http://www.airtronics.net/media/uplo...sers_Guide.pdf
There 4 functions that doesn’t adjust with the transmitter, you will have to do these functions manually on the esc :
Cut-off voltage
Reverse (enable/disable)
Thermal protection
Timing advance (disabled/enabled) at disable is the blinky mode and the last 3 functions will be disable at the transmitter.

The functions that are adjustable with the transmitter are :
Full brake rate
Drag brake
Feel drive
Neutral brake feel
Brake feel
Boost rate timing advance (only if the timing advance is enabled on the esc)
Turbo (only if the the timing advance is enables on the esc)
Power mode (only if the timing advance is enables on the esc)

At the display you have the batt volt, temp of the esc, temp of the motor (it’s not all motor that show the temp)

When you adjust manually (count the led on the esc) some of the parameter are by multiple of 10 (10%,20%....to 100%) but on the transmitter these are by multiple of 1 (1%,2%...to 100%) that what I call fine tuning.. and you can do it on the driver stand