Originally Posted by
BenG477
Hello I have a shock shaft that keeps pulling out of the shock end and I am putting on new ends each time. I was wondering if someone could tell me what the thread pitch is and the die size? I have guessed at 4mm but my 4 x 1 and 4 x .7 dies nuts just dont seem right. Any help would be appreciated.... Thank you.
I was having the same problem and the advice I wa given was:
1. Make sure the shafts are screwed all the way into the shock end. I thought mine were, but when I checked I got another 1mm or so into the shock end.
2. Make sure you do not have too much droop. I now have 104 in front and 112 in rear.
No more issues with me.
Is this happening on a certain shock or random?