R/C Tech Forums - View Single Post - Advice on what I think is bogging at lower end
Thread: Advice on what I think is bogging at lower end
View Single Post
Old 09-07-2014 | 02:12 AM
  #24  
dan_vector's Avatar
dan_vector
Tech Elite
iTrader: (27)
 
Joined: Oct 2013
Posts: 4,333
Default
Originally Posted by Geezatec
Sorry I lost track of the thread. Been out of the country. Clutch gap @ .5 is ok. Centax clutch specs is 1mm. I even go lower to .02. Is adjustable It works by centrifugal force. Depending on Idle and the LSN. It bogs cuz the initial break of throttle there is a lean condition. Once you have the correct engine tuning, then adjust the clutch engagement.
I'd say it's the other way around!! You can't tune an engine with a crappy clutch setup! 0.5mm is too tight. It should be 0.6mm with a new shoe resulting in 0.7mm once the shoe is broken in...
dan_vector is offline  
Reply