R/C Tech Forums - View Single Post - Advice on what I think is bogging at lower end
Thread: Advice on what I think is bogging at lower end
View Single Post
Old 09-07-2014 | 12:31 AM
  #23  
snuvet75's Avatar
snuvet75
Tech Master
iTrader: (16)
 
Joined: Apr 2011
Posts: 1,589
Default
Originally Posted by Geezatec
Sorry I lost track of the thread. Been out of the country. Clutch gap @ .5 is ok. Centax clutch specs is 1mm. I even go lower to .02. Is adjustable It works by centrifugal force. Depending on Idle and the LSN. It bogs cuz the initial break of throttle there is a lean condition. Once you have the correct engine tuning, then adjust the clutch engagement.
That's fine. 0.5mm gap was not actually fine. I raised the gap to .8 mm and bogging has been gone. I find that .5mm is fine w 10th scale but not w 8th scale.
snuvet75 is offline  
Reply