Originally Posted by
torg
I got mine from Trinity today. With the "upgraded wire" kit... same wires included in the box... well almost, the box had two black wires and no blue. So stay away from that particular "upgrade".
I tested it on some of my motors tonight.
R1 V7 21.5 - Phase A, B and C - not even close, brand new, never run before, factory 0 - read 35
Schuurspeed Extreme Spec 17.5 v3 - brand new, never run before. factory setting 35 - read 40
Speed Passion Competition 3.0 MMM - brand new, never run before. Red timing board (+10), so said 30, read 43-45
LRP Stock spec X20 21.5 - used. 37.5 timing insert, read at 40.
Trinity Killshot High RPM 21.5 - used (TA06), timing at 55, read at 40. Then at 0, read -7
Trinity Killshot High RPM 21.5 - used (TB04), timing at 50, read at 35. Then at 0, read -8
images posted
here
My killshots read similar, it would be very cool if more motolysers started sharing. I'll keep mine in my pitbox when I'm at Tamiya, we could compare motolysers as well. make sure they read the same.
Got mine today and I'm beginning to have serious questions about the accuracy of the timing readings. Most of my 21.5 motors read low on the motorlyser compared to the endbell timing. M two Killshots (RPM stator) which I thought were Zero timing stators when I had them at 70 degrees on the endbell, the motorlyser said the timing was ~55 degrees. Simialr results with the R1 as TORG Phase A B &C not even close. What is going on? I haven't checked to see if there is any software updates, I'm running the motorlyiser as it came. If the Motorlyser is correct, it is going to open a lot of peoples eyes.
OH BTW my BOSS 25.5 motor at 45 degrees on timing the label, read 58 degrees.
Some the few results I've seen here and elsewhere, the motorlyser is at least being consistent.
Killshot 21.5 RPM end bell timing seems to read about 15 degrees too high.
R1 stator timing is a 35 to 36 degrees instead oof the reported 30.
R1 phasing appears to be off.
Can anyone speak to the accuracy of the motorlyser timing readings (either the average or the individual sensors)?