Originally Posted by
wayboarder
Start with this rear end.
Brass c block
3+0 pill ( 3 degree toe 0 anti squat)
Rm plastic rear arms with hubs all the way forward.
Shocks all inside on rear tower, inside on arm
No shims under rear ball stud mount. (Assuming plastic)
Rear shocks
Green springs on 3x1.4 30 wt.
2 limiters
Try to gear around 100 total teeth. (Moves motor closer to rear axle)
If you still need extra help squaring up, use .5 degree outer hubs
If you need more stability in sliding rear in corners, longer rear link.
You can also add more limiters in the front shocks. Will place more weight on the rear. Also lower rear ride height 1mm.
Biggest thing i found for track like that was loosening slipper off a couple turns as well.