Originally Posted by
cdraughon
So after making sure my shock ends were screwed all the way in, I noticed the right front a arm falls lower than the left front a arm by about 2mm. I removed the shocks, all of the links and made sure the droop screws were backed all the way off. Still, the right arm falls further than the left. I confirmed the kick up pills were the same on both sides. Any ideas what would cause this?
I stripped everything down to the chassis and found the a arm to be tweaked causing the difference in droop measurements. Replaced the arm and now both measure the same.
Now, setting the front droop to 95mm as measured from top center to bottom center of the shock mount screws has very little droop. The a arms are nearly level when the car is elevated. This looks like less droop than Drakes car in his YouTube suspension video.