James321

Thesaint what motor are you running and please check which firmware you are using. Also what exactly would u like the esc to do better?

Vivo I can help you setup the radon. Here is my setup for 17.5.

Radon pro(V1.1 program)+ actinium 17.5, 13.5, & 21.5
TH1: Punch Rate A: 30
TH2: Punch Rate B: 30
TH3: TH SW Point: 1%
TH4: Slope: Custom(max out the curve)
T1: Timing Boost:0
T2: BT Start RPM: 7000
T3: BT End RPM: 16000
T4: Boost Slope: Linear
T5: Power Saving Mode: No
T6: Turbo Boost: 0
T7: TB Activation: TH
T8: Turbo Delay: 0.05s
T9: TB Start RPM: ---
T10: TB on slope: instant
T11: TB off slope: instant
T12: Turbo K LVL: 0
T13: Turbo T LVL: 0
B1: Initial brake : Drag brake
B2: Drag brake : 15%
B3: Brake force : 87.5%
B4: Brake rate A : 20
B5: Brake rate B : 20
B6: Switching point : 50%
B7: Brake curve : Linear


Here is my current modified setup as well.

Radon pro(V1.3 program)+ actinium 4.5(-3timing) or 5.5(-2timing)
TH1: Punch Rate A: 2
TH2: Punch Rate B: 3
TH3: TH SW Poiint: 80%
TH4: Slope: Linear
T1: Timing Boost: 1
T2: BT Start RPM: 18000
T3: BT End RPM: 40000
T4: Boost Slope: Linear
T5: Power Saving Mode: No
T6: Turbo Boost: 9
T7: TB Activation: TH
T8: Turbo Delay: 0.05s
T9: TB Start RPM: ---
T10: TB on slope: 6deg/0.1s
T11: TB off slope: instant
T12: Turbo K LVL: 0
T13: Turbo T LVL: 0
B1: Initial brake : Drag brake
B2: Drag brake : 19%
B3: Brake force : 87.5%
B4: Brake rate A : 20
B5: Brake rate B : 20
B6: Switching point : 50%
B7: Brake curve : Linear

-James Davenport