Originally Posted by
xrayaustin
That's one of the... if not the worst broken arm I've ever seen on any chassis haha. Be proudof that one buddy.
But on a serious note. to do that much damage bending pins and camber links to that degree. U might want to check bulkheads and motor mount and even chassis flatness. Seems like u took a very hard hit. A whole tear down would be required in my book haha
Cheers! I think!!
And yes, full rebuilt is happening this week. I did stick it on the setup station, including tweak, and it wasn't that bad actually. But yes, strip down happening.
Originally Posted by
niznai
As for prices, I don't think Yokomo would have been more expensive ( I just bought some spares for my BD7). Then again, I buy everything overseas.
I was comparing prices on Banzai, part v part, tamiya vs yokomo. Tamiya won.