Originally Posted by
metalnut
I'm in the final stages of assembling a RC12R5.2 kit and I hit a little snag. Using a Futaba S9650 servo and a small Kimgrough servo saver, one of the ballcups attached to the back of the saver hits the servo when the wheels are turned to the left. If I adjust the ballcup to be perfectly vertical it clears the servo, but if it twists a bit the edge of it hits the servo case.
Is there a good fix or trick for this?
Assuming I understand your explanation correctly, I would just recommend setting your steering throw so that the endpoint is just before the ballcup hits the servo case. You should still have plenty of steering throw.
(This is what I have done on every one of my 12th scales...)