R/C Tech Forums - View Single Post - Tekno ET48 Thread
Thread: Tekno ET48 Thread
View Single Post
Old 08-02-2014 | 02:25 PM
  #3192  
One Mile Up's Avatar
One Mile Up
Tech Adept
 
Joined: May 2014
Posts: 140
From: Colorado
Default
Originally Posted by Vegetable
Hi

I'm new here to this forum bit have just picked up an et48 and it's a beast. But on my first run out I've cracked a front drive shaft at the pin end that goes into the diff and the pin has come loose. Is this a known problem with these drive shafts. This is not the centre front drive shaft but the steel one going to the wheel.

Thanks
Not that I've heard/seen... This is my first electric r/c truggy and I have already beat the snot out of it on the track. Many hard landings and I have even caught the spikes they use to drive the pipe that is along the track a couple times. SO - in my experience thus far with the truck, it's pretty solid! Takes a lick'n and keeps on tick'n!
One Mile Up is offline  
Reply