Posted this on the break in thread with no responses yet so I wonder if anyone here has any advice:

Breaking in a new nova p5 with Byron's 30%. Engine starts fine but I can't get it to stay running, when I pull the igniter off it dies after about 5-10 seconds unless I add throttle input. The idle does not slow or speed up before it dies it just shuts off. I have leaned the low needle about 4 hours and it does not die when I apply full brake, should I lean the high speed needle at this point? I haven't touched it yet or continue to lean the low end?

I have since leaned the low end a little more to where it is beginning to be in from flush. It now idles fast for abut 2-3 seconds and then slows just a bit before it dies, I am trying to complete some low speed (about 20-30%throttle) runs to keep it warm and it will occasional die when i remove throttle input, but does not die when brakes are applied. I just dont want to lean the low end too much and have it cause any damage.